|
|
Starter sometimes clicks but won t start AMT600
I have a John Deere AMT600 that I bought new in the late 1980's. Recently it does not always turn over the starter when ignition is turned to start. Sometimes it just clicks. If I keep turning the ignition switch to start it will eventually turn over and start. I have good battery, new cable, and have replaced starter. I checked the voltage to the solenoid and it is 12.6 when key is turned to start. Would the neutral start switch have any effect on this intermittent problem? Also should I check the ignition switch?
|
|
Add Photo
Bookmarks: |
|
|
|
Starter sometimes clicks but won t start AMT600
Thanks for the reply. I checked the ground connections from the battery to the post under the seat. I removed the cables from the post and cleaned the ends of the cable. I had replaced the main hot wire from the battery to the large connection on the starter. When I checked the ground wire from the battery to the post on the engine it showed continuity. I wonder if I should replace the large ground wire from the battery to the ground post on the engine. I guess that the large ground wire could show continuity but could still be damaged internally.
|
|
Add Photo
Bookmarks: |
|
|
|
Starter sometimes clicks but won t start AMT600
Do you mean pulling off the connector for the wire that comes from the ignition switch and putting 12v on the pick tab manually to see if it starts?
|
|
Add Photo
Bookmarks: |
|
|
|
Starter sometimes clicks but won t start AMT600
I actually did this with the starter off the vehicle. It always picked and started with 12v on the big lug and touching the pick tab with 12v. On the vehicle it always picks but does not always turn the starter over. I am going to do all the voltage tests on the vehicle as I try to start it looking for voltage drops somewhere in the circuit. I found a you tube video which goes through the process of doing this. Will let you know what I find.
|
|
Add Photo
Bookmarks: |
|
|
|
Starter sometimes clicks but won t start AMT600
Today I removed the main ground wire from the battery and checked it. It looked and tested ok. I made sure I had a good star washer on each end connectors. I hooked up a volt meter to the hot lug on the starter and it showed 12.5 volts. Is this enough to ensure the starter turns over every time. Sometimes it starts right away. Other times it clicks a couple of times and then starts. Eventually it always starts.
|
|
Add Photo
Bookmarks: |
|
|
|
Starter sometimes clicks but won t start AMT600
I just did the voltage drop tests on the starter circuit. The battery was good. The test of the large positive cable to starter was good. The ground test was good. The battery to the pick circuit was not good. When it fails the voltage from the positive battery to the pick circuit tab when key turned to start should go from 12.5 to ground. It goes to about 4v. I am going to replace the ignition switch. Will let you know what happens.
|
|
Add Photo
Bookmarks: |
|
|
|
Starter sometimes clicks but won t start AMT600
Just read your post. Got ignition sw and did not fix prob. I will try to locate the relay and check it. Thanks for the post.
|
|
Add Photo
Bookmarks: |
|
|
|
Starter sometimes clicks but won t start AMT600
Are you sure that my old amt-600 has this relay? I cannot find it in the parts catalog.
|
|
Add Photo
Bookmarks: |
|
|
|
Starter sometimes clicks but won t start AMT600
Ok. thanks I will check them.
|
|
Add Photo
Bookmarks: |
|
|
|